Skip to content 
It’s not surprising for DirecTV users to encounter difficulties with their receivers. For that reason, people are encouraged to have an idea of how to reset the DirecTV box.
It’s a simple act that can save you from a lot of frustrations and problems such as poor picture, issues with sound and so on. Watching television should be a fun and delightful moment.
Nobody wants to miss their favorite program because they spent most of their time trying to figure out what’s causing pixelation, DirecTV guide not showing, bad picture quality or no audio. On that note, this guide should point you in the right direction on resetting your DirecTV receiver.
Table of Contents
How to reset DirecTV box
If there is a problem with your DirecTV box, then it could be as simple as resetting the DirecTV receiver and in no time you’re revelling in your favourite program. Follow the steps we’ve outlined below to reset your DirecTV box.
Method 1: Use the reset button
Oftentimes, devices come with a reset button that you can use to refresh it. If you notice that your DirecTV receiver isn’t functioning as intended, it may be time to restart it. This way, any minor issues are rectified in due time and you can continue watching programs using your DirecTV service.
- Look for the reset button. Usually, it’s a tiny red button situated inside the access card door of the DirecTV receiver. With some receivers, it’s found on the side.
- After you’ve found the red button, press it and let the receiver reboot. Wait patiently as this could take several minutes.
- Once the reboot process is complete and the receiver is back on, tune in to your desired TV channel and relish the various programs.
- If you have a Genie Mini, you’ll need to take the time to restart the main Genie as well. This works to restore the local channels.
Method 2: Unplug the receiver
Another way to reset your DirecTV box is to simply unplug the receiver and let it sit for a few seconds. This is how you go about it.
- Remove the power cord from the electrical outlet and wait for at least 15 seconds. You can then plug it back in.
- Your receiver has a power button located at the front panel. Press the power button and let the receiver reboot. This will take a few minutes to complete.
- Enjoy stress-free and uninterrupted television viewing.
Method 3: Restore the receiver to factory settings
When you’ve tried the first two methods to no avail, the last resort is to restore the receiver back to factory settings. This means you’ll start on an entirely clean slate. Keep in mind, this method will remove all of your playlists, customized preferences and favorites. Proceed as follows;
- Find the blue power button located at the front of your receiver. Press and hold it for a few seconds.
- After about 20 seconds, release the power button. This should reset your DirecTV box back to the factory settings. You will need some time to set it up once again.
- If this doesn’t work out, consider refreshing the service. In that case, just go to My Equipment & Features and click on Refresh my service. The service will be interrupted for some minutes as it reboots. Check to confirm that everything is back up and running.
Final Thoughts
DirecTV are known for their technical setbacks but with that said, don’t fret because a simple reset of your receiver will likely resolve any underlying problems in no time.
Use the instructions laid out in this piece to reset your DirecTV box in just a few steps. And if that doesn’t help then you may have experienced equipment failure which can be remedied.
FAQs
How long does it take for a DirecTV box reset?
A complete reboot of your DirecTV box might take up to 10 minutes or less. The time it takes usually varies.
Why is my DirecTV box not working?
There might be an interruption in the power supply of the receiver. Check the power cord as well as the electrical outlet.
Can you reset the DirecTV box using a remote control?
Yes, it’s very much possible. Just press the Menu button and scroll down to the settings. From there, you will be able to locate the Reset option. Select it and allow the receiver to reboot.
